The hitch you're needing is the Curt Class II, part # C12207, which we do offer.
If you were wanting to use the hitch for towing purposes (as opposed to using it as an attachment point for a bike rack or cargo tray) you'll also need a trailer wiring harness like part # 119178KIT, a ball mount like part # C45017 and a trailer ball like # 19256 for a 1-7/8 ball or # 19258 for a 2 inch ball. view full answer...
To determine the amount of rise or drop in a ball mount that you will need to tow a trailer level there are a couple of measurements needed. First make sure the trailer is on level ground. Use the jack to make the trailer level then measure from the ground to the bottom of the coupler.
Then on the vehicle measure from the ground to the top of the receiver opening on the trailer hitch. If the vehicle is higher then the difference is the amount of drop you will need. If the trailer is higher... view full answer...
It sounds like you are describing the Titan Chain # TC1130 which use the ladder pattern as is shown in the attached picture.
These are Class S compatible chains but you will want to make sure to follow any instructions in your owner's manual regarding snow tire chains as well.
I have also attached a link to our selection of tire chains that are compatible with the 195/65-15 size tires on your 1993 Volvo 940 Series that you can filter through if these are not what you are looking for. view full answer...
Thank you for providing your two photos showing the Draw-Tite hitch # 36445 that you have acquired for use on your 1994 Volvo 940 Series wagon.
I was able to confirm with my technical contact at Draw-Tite that this hitch (which incidentally is no longer manufactured) is a correct fit for your vehicle and is a Class II-rated hitch with a tongue weight capacity of 300-lbs and a gross towing weight capacity of 3500-lbs. (Tongue weight is a measure of the downward force on the hitch applied... view full answer...
Go To Results